Search
33 articles for “normal concrete”
-
Seismic Analysis of G+10 Storey Building Using Structural Light weight and Normal Weight Concrete
Abstract: Concrete is considered a slight weight concrete which has density of less than 2000 kg/????3. The Structural Lightweight Concrete (SLWC) is mainly used to reduce the dead load of concrete structure. The purpose of this research is to examine and compare the results of Structural lightweight concrete by adding perlite with Normal Weight Concrete multistorey building. Often these multistorey buildings are constructed of ordinary concrete, steel, and other materials, and …
Published in International Journal of Structural Engineering and Analysis · Vol. 8, Issue 2, 2022 · pp. 1–19 Read article
-
Taguchis Parameter Design Approach to normal cement concrete mixture proportioning
Abstract: This paper presents the results of the optimization of normal cement concrete mixture using Taguchi approach. The Taguchi experiments were designed using an L9 orthogonal array with three factors and three levels each. The water-cement ratio (W/C), total aggregate-cement ratio (TA/C) and total aggregate-water ratio (TA/W) were treated as the control factors. The effects of the water-cement ratio, total aggregate-cement ratio and total aggregate-water ratio on the compressive strength were …
Published in International Journal of Geological and Geotechnical Engineering · Vol. 4, Issue 2, 2018 · pp. 23–29 Read article
-
Performance of High Volume Fly Ash Concrete Using Local Power Plant Fly Ash
Abstract: Total production of fly ash in Indian Thermal Power plants is approximately 160 million tons annually. Except some super power plants, the quality of fly ash is said to be inferior in most of the power plants. The suitability of fly ash from local power plants for production of high volume fly ash (HVFA) concrete is not tested so far. The aim of the present investigation is to ascertain whether …
Published in International Journal of Composite and Constituent Materials · Vol. 1, Issue 1, 2015 · pp. 07–13 Read article
-
Structural Behavior of Fiber Reinforced Concrete
Abstract: It’s a structural behavior research was done on normal concrete because it possesses low tensilestrength shows cracking. The addition of fiber can enhance the compressive and tensile properties ofconcrete. An experimental study was conducted to evaluate the compressive and tensile strength offiber-reinforced concrete, confirming the improvements in these mechanical properties. The variousaspects covered are compression test, split tensile strength, Effects of fibers on concrete. The study isdone on the comparison …
Published in International Journal of Concrete Technology · Vol. 10, Issue 1, 2024 · pp. 18–24 Read article
-
Determination of the optimum magnetic exposure time for magnetic water concrete
Abstract: The purpose of this study was to investigate the effect of magnetic water on the workability and compressive strength of concrete, and also to find the optimum time for exposing water to magnetic field, for which maximum compressive strength of concrete will be achieved. In this research, water was exposed to magnetic field of 336mT per magnet for a duration of 12, 18, 24, 36, and 96 hours, after which …
Published in International Journal of Construction Engineering and Planning · Vol. 6, Issue 1, 2020 · pp. 34–42 Read article
-
An overview on the rheology of recycled aggregate concrete with the influence of chemical admixtures
Abstract: : Concrete is one of the most widely used construction material because of its property to be moulded into any kind of structure and shape due to its fluidity at early stages. The fresh properties of concrete can be characterized by its flow behaviour. Rheology is the scientific description of flow properties. Super-plasticizers and air-entrainers are some of the most used chemical admixtures that affect the rheological parameters of fresh …
Published in International Journal of Concrete Technology · Vol. 5, Issue 1, 2019 · pp. 14–24 Read article
-
To Study Mechanical Properties of Concrete by Using Industrial Waste Material
Abstract: Concrete is a very important material with cement, water, aggregate and admixture as contents. Due to increasing pollution and demand of concrete, its production should be environmental friendly. In this study, we emphasize on environment friendly concrete. The proportion of silica fume was as follows: add 3%–15% in interval of 3% by weight of cement in concrete and fly ash was add 5%–25% in interval of 5% by total weight …
Published in International Journal of Construction Engineering and Planning · Vol. 5, Issue 1, 2019 · pp. 18–27 Read article
-
Prediction of Compressive strength of Periwinkle Shell Aggregate Concrete Using a Quadratic Polynomial Function
Abstract: In this study, a mathematical model is developed to predict the compressive strength of normal concrete made with periwinkle shell as coarse aggregate using a quadratic polynomial function. The response function is expressed as a multivariable function of the proportions of the component materials (water, ordinary Portland cement, sand and periwinkle shell). A total of thirty experimental runs were used to demonstrate the applicability of the mathematical model developed. The …
Published in International Journal of Concrete Technology · Vol. 6, Issue 2, 2020 · pp. 10–21 Read article
-
A Study on Mechanical Properties and Fracture Behavior of Chopped Fiber Reinforced Self-Compacting Concrete
Abstract: The development of self-compacting concrete (SCC) is innovatory landmark in the history of construction industry resulting in predominant usage of SCC worldwide nowadays. It has many advantages over normal concrete in terms of enhancement in productivity, reduction in labor and overall cost, excellent finished product with excellent mechanical response and durability. Further, incorporation of fibers enhances its properties specially related to post crack behavior of SCC. Hence, the aim of …
Published in International Journal of Construction Engineering and Planning · Vol. 3, Issue 1, 2017 · pp. 90–122 Read article
-
A Study on Self Compacting Concrete using Portland Pozzolana Cement
Abstract: Self-compacting concrete (SCC) is a type of highly flowable concrete that fills each and every corner of congested formwork without the need for mechanical vibration as it is placed by means of its own weight. Generally, the SCC is prepared by using Ordinary Portland Cement (OPC) with mineral and chemical admixtures. Portland Pozzolana Cement (PPC) itself contains some amount of fly ash, thus given the motivation to prepare the SCC …
Published in International Journal of Concrete Technology · Vol. 6, Issue 2, 2020 · pp. 1–9 Read article
-
Effect of Accelerated Curing and Normal Curing Regimes on UFGGBFS-Based Semi-Lightweight Concrete
Abstract: This paper deals with the performance of semi-lightweight concrete (sLWC), prepared by using calcite powder pellets as coarse aggregates which was improved by partial replacement of cement with UFGGBFS (ultrafine ground granulated blast-furnace slag). Cement could be replaced by UFGGBFS as 0%, 5%, 10%, 15%, 20%, 25%, 30%, 35%, 40%, 45%, 50%, 55%, 60%, 65%, and 70% to enhance the strength and durability properties of concrete. High-range water-reducing admixtures (HRWA) …
Published in International Journal of Concrete Technology · Vol. 5, Issue 1, 2019 · pp. 1–7 Read article
-
Effect of variation of Elevated Temperature on Compressive Strength of Metakolin concrete
Abstract: It has been found that high early temperature has negative impacts on later compressive strength of concrete. Some researchers investigated the adverse effect on long term strength of concrete due to high initial temperature. The effect of temperature on different properties of concrete is considerable and remained the subject of research activities of a lot of researchers. Different investigators moved in different ways and investigated temperature effect by changing different …
Published in International Journal of Concrete Technology · Vol. 2, Issue 2, 2016 · pp. 9–16 Read article
-
Influence of GGBFS on the Mechanical Properties of the Water Cured Fly Ash Aggregate-Based Geopolymer Concrete
Abstract: Abstract Conventional concrete consists of cement, sand as fine aggregate and gravel, limestone or granite in various sizes and shapes as coarse aggregate including with water. In the present work, the feasibility of using industrial inorganic polymeric residues wastes as a total (100%) replacement to the traditionally used normal conventional concrete materials is examined in the preparation of the geopolymer concrete (GPC). In this GPC, the cement is totally replaced …
Published in International Journal of Concrete Technology · Vol. 2, Issue 1, 2016 · pp. 54–64 Read article
-
Experimental Investigation On Replacement Of Fine Aggregate With Manufactured Sand And Partial Replacement Of Cement With Ggbs
Abstract: Concrete is the most widely used construction material in civil engineering industry because of its high structural strength and stability. The concrete industry is looking for supplementary cementitious material or industrial by product with the objective of reducing the carbon dioxide emission which is harmful to environment. Ground granulated blast furnace slag (GGBS) is the solid wastes generated by industry are used as a replacement material for cement. Manufactured sand …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 1–6 Read article
-
Effect on Strength Properties Concrete Amalgamation of Recycled Reinforced Aggregate -An Experimental Study
Abstract: Concrete is a combination substance which has turn into a universal and essential as its intrinsic in character brought an uprising application. Use of concrete in construction lead to construction of surplus desecrate subsequent to destruction of the variety of structures. The waste generated is enormous and uncontrollable. So, in this present research is to verify the potency of concrete with normal aggregate and recycled aggregate in addition to enlarged …
Published in International Journal of Concrete Technology · Vol. 6, Issue 1, 2020 · pp. 7–15 Read article
-
Efficient Protective Materials of Columns under Vehicle Collision Loading: A Review
Abstract: Consideration of efficient protective materials in reinforced concrete columns under impact loading are essential in the current scenario. Regular increment in numbers of automobiles generates a risk to public structures, so exploration of most efficient and protective structures to reduce the appropriate deflection and peak impact force takes place. The behaviour of different types of columns like composite columns, reinforced concrete columns and encased columns subjected to impact loading have …
Published in International Journal of Transportation Engineering and Traffic System · Vol. 8, Issue 2, 2022 · pp. 9–21 Read article
-
Mathematical Model to Monitor Concrete Compressive Strength Partially Replaced with Periwinkle and Palm Kernel Shell as Aggregate
Abstract: This research work monitor that application of periwinkle and palm kernel shell as partial replacement for aggregate, the study are carried out applying modeling and simulation techniques, concrete are normally heterogeneous in most cases, but the study try to examine the growth rate of the material on their compressive strength, such process were carried out using these two locally sourced material at different percentage of replacement for aggregate, the study …
Published in International Journal of Construction Engineering and Planning · Vol. 9, Issue 2, 2023 · pp. 6–28 Read article
-
Experimental Study on the Properties of Self-Curing Concrete
Abstract: This paper highlights the effect of curing agent polyethylene glycol (PEG-400) in the performance of concrete. The chemical agent PEG is used with different percentage; 1%, 2% and 3% to the weight of cement. Super plasticizer named glenium was used to improve the workability of concrete. The property such as compressive strength and split tensile strength of concrete was examined with normal curing and self-curing at 7 days and 28 …
Published in International Journal of Concrete Technology · Vol. 3, Issue 1, 2017 · pp. 8–13 Read article
-
Comparative Study on the Effect of Acidic and Alkaline Mixing Water on Concrete Strength
Abstract: AbstractThe overall performance and durability of concrete are significantly influenced by the quality of water. The strength of the concrete is mostly influenced by the pH of the mixing water, which also affects the hydration process of the cement. This study investigates how different pH levels of water affect the compressive strength of concrete. Three types of mixing water were prepared with pH values of 3.64, 6.90, and 10.21 by …
Published in International Journal of Concrete Technology · Vol. 12, Issue 1, 2026 · pp. 7–15 Read article
-
Impact of Silica Fume on High-Strength Concrete
Abstract: For many decades, concrete has been the primary material used in construction because of itsreliability under normal conditions. However, certain applications necessitate concrete withexceptionally high compressive strength and durability, particularly in aggressive environments.Consequently, achieving compressive strengths in the range of 60–140 MPa is critical for thesedemanding situations. Silica fume, a by-product of silicon and ferrosilicon smelting processes, hasgained recognition as an effective cementitious material for enhancing concrete properties. Thisdissertation investigates …
Published in International Journal of Concrete Technology · Vol. 10, Issue 1, 2024 · pp. 25–31 Read article