International Journal of Composite and Constituent Materials
Volume 6, Issue 2 (2020)
Published
Table of contents
-
Corrosion Inhibition Studies of Triazinedithiol Inhibitors for Mild Steel in an Acid Chloride Solution
Abstract: Two environmental pleasant triazine dithiol inhibitors 6-diallylamino-1,3,5-triazine-2,4-dithiol monosodium (DAN)and 6-dibutylamino-1,3,5-triazine-2,4-dithiol monosodium (DBN) was synthesized and their corrosion inhibition for slight metallic in a 1 M HCl solution turned into studied the usage of weight reduction methods, electrochemical measurements, and scanning electron microscopy (SEM) techniques. The inhibition efficiency of both DAN and DBN improved with increases in inhibitor concentration but decreased with increases in temperature. Results from potentiodynamic polarization and EIS …
Published in International Journal of Composite and Constituent Materials · Vol. 6, Issue 2, 2020 · pp. 1–10 Read article
-
Mechanical Behavior of AA7075/Glass Fiber Reinforced Polymer Composites
Abstract: This paper reports on the mechanical properties of As-cast and heat-treated AA7075 polymer composites reinforced with glass fibers from 1 to 5 wt%. The polymer composites were fabricated using the Compo casting method, in which short glass fibers were introduced into the vortex created in the molten alloy through an impeller rotated at 500 rpm. The molten mass was thoroughly stirred and poured into permanent molds and squeezed under pressure. …
Published in International Journal of Composite and Constituent Materials · Vol. 6, Issue 2, 2020 · pp. 11–20 Read article
-
Effect of Abrasive Water Jet Machining Parameters—An Experimental Investigation
Abstract: Machining studies on the fiber reinforced polymer composites is vital requirement for the composites application in different fields. Particularly advanced machining techniques like abrasive water jet machining can be machined with higher accuracy and distortion free composites. In this work aims to study the abrasive machining parameters on the basalt fiber polymer composites. The woven basalt fiber reinforced polymer composites were prepared using hand layup techniques. The machining effect of …
Published in International Journal of Composite and Constituent Materials · Vol. 6, Issue 2, 2020 · pp. 21–23 Read article
-
Tribological Behavior of Chilled Aluminum Alloy (LM-13) Reinforced with Titanium Carbide (TiC) Metal Matrix Composites for Automobile Applications.
Abstract: In the present research, aluminum alloy (LM13) Metal Matrix Composite (MMC) is prepared by stir casting technique and is reinforced with titanium carbide (TiC) particulates in the weight percent ranging from 3 wt.% to 15 wt.% in the steps of 3 wt.%. The dispersoid i.e. TiC particle size added varies between 100–200 µm. The resulting MMCs were solidified under the influence of copper chill of 25 mm thickness to study …
Published in International Journal of Composite and Constituent Materials · Vol. 6, Issue 2, 2020 · pp. 24–46 Read article
-
Experimental Study on Effect of Momentum Transfer Hydrocarbon Degradation in Stream System
Abstract: This research work demonstrates the significance of individual hydrocarbon degradation in a flowing stream system and the effect of the momentum transfer on the concentration of the individual hydrocarbon was examined on the influence of period of exposure (time) on the environment as well as the distance of dispersion. The substrate concentration variation was monitored with respect to time and distance as well as reciprocal of the substrate established by …
Published in International Journal of Composite and Constituent Materials · Vol. 6, Issue 2, 2020 · pp. 47–55 Read article