Rajendra Ganapati Hegde, K G Gupta | International Journal of Concrete Technology | Vol 12, Issue 2 | ISSN: 2456-8317
Abstract
This research examines the combined influence of epoxy resin and Alccofine when used as partial substitutes for cement in producing sustainable, high-performance concrete. The study aims to improve both strength and durability properties while simultaneously reducing cement usage and its environmental impact. Concrete mixes were prepared with epoxy resin contents of 0%, 5%, and 10% by weight of cement, along with Alccofine replacement levels of 5%, 10%, and 15%. The experimental program involved assessing compressive strength, split tensile strength, and flexural strength at curing periods of 7, 28, and 56 days. Additionally, durability performance was evaluated through tests on water absorption, resistance to acidic environments, and rapid chloride permeability to understand long-term behavior under aggressive exposure conditions.The results indicated that the mix containing 5% epoxy resin and 10% Alccofine exhibited the most balanced performance across both strength and durability parameters. This optimum combination resulted in an increase of approximately 24% in compressive strength and 18% in flexural strength compared to the control mix, along with a significant reduction in water absorption, indicating improved matrix densification and reduced porosity. Microstructural analysis using Scanning Electron Microscopy (SEM) confirmed the formation of a denser and more homogeneous internal structure. This improvement is attributed to the combined effect of Alccofine-induced pozzolanic reactions, which contribute additional calcium silicate hydrate (C–S–H) formation, and the polymeric film-forming characteristics of epoxy resin, which enhance particle bonding and reduce micro crack propagation. Overall, the study shows that the combined use of epoxy resin and Alccofine can significantly improve the mechanical performance and durability of concrete. The findings highlight the potential of such hybrid cementitious systems in developing sustainable construction materials with enhanced resistance to chemical attack and improved long-term structural performance, aligning with the objectives of eco-efficient and resource-optimized construction practices.
References
[1] C.J. Deng, F.N. Dang, X.Z. Chen, Z. Miao, L.L. Chen, Experimental Study on Grouting Effect and Mechanical Properties of the Rockfill Materials Grouted with SCM, Advances in Civil Engineering. 2020 (2020) 8834686. https://doi.org/10.1155/2020/8834686. [2] B. Balakrishnan, N.H.A. Khalid, M. Ismail, Effect of heating and cooling technique on residual compressive strength and weight loss of grout containing High volume fly ash, IOP Conference Series: Earth and Environmental Science. 220 (2019). https://doi.org/10.1088/1755-1315/220/1/012045. [3] A. Bereda, B. Asteray, Strength and Microstructural Investigation of Quaternary Blended High-Strength Concrete, Advances in Civil Engineering. 2021 (2021) 8404988. https://doi.org/10.1155/2021/8404988. [4] V. Septriansyah, A. Saggaff, S. Saloma, Characteristics of nanocomposite polymer with temperature variation and heating time by using simple mixing method, International Journal of Advanced Technology and Engineering Exploration. 8 (2021) 651–661. https://doi.org/10.19101/ijatee.2021.874037. [5] G.S. Balan, A.M. Krishnan, S. Saravanavel, M. Ravichandran, Investigation of hardness characteristics of waste plastics and egg shell powder reinforced polymer composite by stirring route, Materials Today: Proceedings. (2020) 8–11. https://doi.org/10.1016/j.matpr.2020.06.545. [6] N. Mashaan, A. Chegenizadeh, H. Nikraz, Laboratory Properties of Waste PET Plastic-Modified Asphalt Mixes, Recycling 2021, Vol. 6, Page 49. 6 (2021) 49. https://doi.org/10.3390/RECYCLING6030049. [7] Z.A. Rid, S.N.R. Shah, M.J. Memon, A.A. Jhatial, M.A. Keerio, W.I. Goh, Evaluation of combined utilization of marble dust powder and fly ash on the properties and sustainability of high-strength concrete, Environmental Science and Pollution Research. 29 (2022) 28005–28019. https://doi.org/10.1007/S11356-021-18379-1/FIGURES/11. [8] M.J. Memon, A.A. Jhatial, A. Murtaza, M.S. Raza, K.B. Phulpoto, Production of eco-friendly concrete incorporating rice husk ash and polypropylene fibres, Environmental Science and Pollution Research. 28 (2021) 39168–39184. https://doi.org/10.1007/S11356-021-13418-3/FIGURES/19. [9] M. Nikookar, N.A. Brake, H.H. Asli, M. Adesina, A. Rahman, T. Selvaratnam, R.K. Bradley, Durability, workability, and setting time of cementitious systems containing chloride-rich oil and gas production wastewater, Construction and Building Materials. 403 (2023) 132862. https://doi.org/10.1016/J.CONBUILDMAT.2023.132862. [10] Gayathri. K, Ravichandran. K, Saravanan. J, Durability and Cementing Efficiency of Alccofine in Concretes, International Journal of Engineering Research And. V5 (2016) 460–467. https://doi.org/10.17577/ijertv5is050627. [11] M.S.I. Zaini, M. Hasan, L.S. Yie, K.A. Masri, R. Putra Jaya, M. Hyodo, M.J. Winter, Effect of optimum utilization of silica fume and eggshell ash to the engineering properties of expansive soil, Journal of Materials Research and Technology. 14 (2021) 1401–1418. https://doi.org/10.1016/j.jmrt.2021.07.023. [12] T. Landu, M. Ananthkumar, C. Prakash, A.C. Bharath Krishnaa, M. Sasi, Dolomite rock sand as fine aggregate replacement in construction activities: A comparative study, Materials Today: Proceedings. 46 (2019) 5148–5152. https://doi.org/10.1016/j.matpr.2020.10.678. [13] M. Nuruzzaman, J.C. Kuri, P.K. Sarker, Strength, permeability and microstructure of self-compacting concrete with the dual use of ferronickel slag as fine aggregate and supplementary binder, Construction and Building Materials. 318 (2022) 125927. https://doi.org/10.1016/j.conbuildmat.2021.125927. [14] R.H. Faraj, H.F. Hama Ali, A.F.H. Sherwani, B.R. Hassan, H. Karim, Use of recycled plastic in self-compacting concrete: A comprehensive review on fresh and mechanical properties, Journal of Building Engineering. 30 (2020) 101283. https://doi.org/10.1016/j.jobe.2020.101283. [15] R.A. Schankoski, P.R. de Matos, R. Pilar, L.R. Prudêncio, R.D. Ferron, Rheological properties and surface finish quality of eco-friendly self-compacting concretes containing quarry waste powders, Journal of Cleaner Production. 257 (2020) 120508. https://doi.org/10.1016/j.jclepro.2020.120508. [16] J.T. Kolawole, R. Combrinck, W.P. Boshoff, Rheo-viscoelastic behaviour of fresh cement-based materials: Cement paste, mortar and concrete, Construction and Building Materials. 248 (2020) 118667. https://doi.org/10.1016/j.conbuildmat.2020.118667. [17] I.M. Belmonte, F.J. Benito Saorin, C.P. Costa, M.V. Paya, Quality of the surface finish of self-compacting concrete, Journal of Building Engineering. 28 (2020) 101068. https://doi.org/10.1016/j.jobe.2019.101068. [18] R. Alyousef, M.A. Khadimallah, C. Soussi, O. Benjeddou, M. Jedidi, Experimental and Theoretical Study of a New Technique for Mixing Self-Compacting Concrete with Marble Sludge Grout, Advances in Civil Engineering. 2018 (2018) 3283451. https://doi.org/10.1155/2018/3283451. [19] S. Du, Q. Zhao, X. Shi, High-Volume Fly Ash-Based Cementitious Composites as Sustainable Materials: An Overview of Recent Advances, Advances in Civil Engineering. 2021 (2021) 4976169. https://doi.org/10.1155/2021/4976169. [20] E. Nthiga Njiru, J. Wachira Muthengia, O. Mulwa Munyao, D. Karanja Mutitu, D. Munyao Musyoki, Review of the Effect of Grinding Aids and Admixtures on the Performance of Cements, Advances in Civil Engineering. 2023 (2023) 6697842. https://doi.org/10.1155/2023/6697842. [21] R. Jeyapragash, V. Srinivasan, S. Sathiyamurthy, Mechanical properties of natural fiber/particulate reinforced epoxy composites - A review of the literature, Materials Today: Proceedings. 22 (2020) 1223–1227. https://doi.org/10.1016/j.matpr.2019.12.146. [22] V. Valasamudram, K. Sairam, R. Dinesh Gopal, K. Sridhar, Study and evaluation of cold joining on metals and non metals combinations (ss, al, acr) using polymer based adhesive, in: Materials Today: Proceedings, Elsevier Ltd, 2019: pp. 2806–2810. https://doi.org/10.1016/j.matpr.2019.12.371. [23] B. Fathi, M. Foruzanmehr, S. Elkoun, M. Robert, Novel approach for silane treatment of flax fiber to improve the interfacial adhesion in flax/bio epoxy composites, Journal of Composite Materials. 53 (2019) 2229–2238. https://doi.org/10.1177/0021998318824643. [24] E. Gartner, H. Hirao, A review of alternative approaches to the reduction of CO2 emissions associated with the manufacture of the binder phase in concrete, Cement and Concrete Research. 78 (2015) 126–142. https://doi.org/10.1016/j.cemconres.2015.04.012. [25] L. Liu, A. Zhou, Y. Deng, Y. Cui, Z. Yu, C. Yu, Strength performance of cement/slag-based stabilized soft clays, Construction and Building Materials. 211 (2019) 909–918. https://doi.org/10.1016/j.conbuildmat.2019.03.256. [26] A. Samabangi, A. Eluru, Industrial copper waste as a sustainable material in high strength SCC, Cleaner Engineering and Technology. 6 (2022) 100403. https://doi.org/10.1016/J.CLET.2022.100403. [27] R.K. Sandhu, R. Siddique, Influence of rice husk ash (RHA) on the properties of self-compacting concrete: A review, Construction and Building Materials. 153 (2017) 751–764. https://doi.org/10.1016/j.conbuildmat.2017.07.165. [28] Bureau of Indian Standard(BIS), IS: 8112 – 1989, Specification for 43 grade Ordinary Portland Cement, Bureau of Indian Standards,New Delhi. (2013) 17.
