Search
345 articles for “frequency”
-
IMAGING OF A FAR SURFACE OBJECT WITH HORIZONTAL LOOP ELECTROMAGNETIC INSTRUMENT
Abstract: An electromagnetic imaging instrument with variable voltage and frequency was designed and constructed to image a far surface metallic object. The methodology involved the transmitted voltage of 250V to the transmitter core with frequency of 300Hz. The liquid crystal display (LCD) module was used to display the computed voltage values after being processed by the microcontroller unit. The constructed instrument took measurement at horizontal profiling to 30m along the surface …
Published in International Journal of Environmental Chemistry · Vol. 5, Issue 1, 2019 · pp. 4–9 Read article
-
Condition Assessment of Structures Using Vibration Technique
Abstract: Structural Health Monitoring grasps the Promise for enhancing the structural performance with an outstanding cost/benefit ratio. Condition assessment is a technique used in health monitoring in the damage detection, to ensure the serviceability and the durability of the structures. In the present report, condition assessment of the structures using low frequency technique is being completed through experimental modal analysis and computational analysis software ANSYS 9.0 over structural elements beam and …
Published in International Journal of Geological and Geotechnical Engineering · Vol. 3, Issue 1, 2017 · pp. 36–46 Read article
-
BASE ISOLATION: EARTHQUAKE RESISTANT CONSTRUCTION TECHNIQUE
Abstract: One of the most effective way of protecting structures against the severe earthquake is the base isolation system. In last few decades base isolation system have gain larger attention as a means in controlling structure failure against seismic hazards. In the base isolation system superstructure is separated from substructure due to which natural frequency of structure gets away from the dominant frequency range of seismic excitation. The effectiveness of an …
Published in International Journal of Structural Engineering and Analysis · Vol. 4, Issue 2, 2018 · pp. 32–37 Read article
-
Dynamic Response of Bridges and its Effect on Soil Medium
Abstract: The analysis of dynamic behaviour of bridge structures that are subjected to moving loads has been one of the research benefits in recent years. Specifically in railway bridges, resonance ensues when the load frequency is equal to a multiple of natural frequency of the structure. Resonance vibrations have been practical in railway bridges, especially subjected to high-speed lines. They are caused primarily because of two reasons: one is the repeated …
Published in International Journal of Structural Engineering and Analysis · Vol. 5, Issue 1, 2019 · pp. 28–34 Read article
-
Dynamic Analysis of Simply Supported Bridge under Vehicle Loads
Abstract: The analysis of dynamic behavior of bridge structures that are subjected to moving loads has been one of the enquiry interests in recent years. Specifically in railway bridges, reverberation ensues when the load frequency is equal to a multiple of natural frequency of the structure. Resonance vibrations have been practical in railway bridges especially subjected to high-speed lines. They are caused primarily because of two reasons: one is the repeated …
Published in International Journal of Structural Engineering and Analysis · Vol. 5, Issue 1, 2019 · pp. 18–23 Read article
-
Effect of Data Length on Estimation of Probable Maximum Precipitation Using Hershfield Method
Abstract: Probable Maximum Precipitation (PMP) represents the greatest depth of precipitation for a given duration that is physically possible over a given size storm area at a particular geographical location and at a particular time of year. PMP is used for estimating probable maximum flood which, in turn, is used for design of major hydraulic structures such as dams and spillways, flood protection works and nuclear power plants. One of the …
Published in International Journal of Water Resources Engineering · Vol. 7, Issue 2, 2021 · pp. 44–49 Read article
-
Detection of PARD Attack Using Key Based Biometric Authentication System Based on Fingerprint Impression
Abstract: Biometric authentication plays a major role in security as these are by nature unique for every human. But the security is compromised when the pattern matching system is not accurate. Authentication system like fingerprint recognition is most commonly used biometric authentication system. In this paper, survey is done on fingerprint recognition techniques. And different approaches are studied in terms of accuracy and performance. As fingerprint may also contain noise; so, …
Published in International Journal of Image Processing and Pattern Recognition · Vol. 3, Issue 1, 2017 · pp. 25–34 Read article
-
Compact Microstrip Patch Antennas Combining Sierpinski and Koch Fractal Geometries With Defected Ground Structure
Abstract: In this paper, a novel technique to compact the size of microstrip patch antennas is proposed. Based on experiments, it is found that by increasing iteration order of fractal geometries with defected ground structure, the resonant frequency of a patch antenna can be extremely lowered and this property can be employed to reduce the size of a microstrip patch antenna. Combination of Koch and Sierpinski fractal shapes are used to …
Published in International Journal of Analog Integrated Circuits · Vol. 3, Issue 1, 2017 · pp. 20–25 Read article
-
Inverse ABCD Parameter Determination Using Spice
Abstract: Spice/Pspice Models using the inverse transmission parameters for linear two port analysis are given. The inverse transmission parameter determination for a circuit using SPICE2/Pspice is carried out. While the first procedure and files are for the calculation of Inverse ABCD parameters where the circuit is purely resistive and dependent sources, the second is for general two port network using linear elements and small signal models of active devices like BJT, …
Published in International Journal of Analog Integrated Circuits · Vol. 3, Issue 1, 2017 · pp. 14–19 Read article
-
An Overview of RF MEMS Components by Microwave Theory and Techniques
Abstract: This paper offers with a rather new location of radio-frequency (RF) technology primarilybased on microelectromechanical systems (MEMS). RF MEMS gives a class of new devicesand components which show advanced high-frequency performance relative to standard(commonly semiconductor) gadgets, and which enable new device abilities. Further, MEMSgadgets are designed and fabricated by means of techniques much like those of very massive-scale integration, and may be synthetic through traditional batch-processing strategies. Inthis paper, the …
Published in International Journal of Analog Integrated Circuits · Vol. 6, Issue 1, 2020 · pp. 53–60 Read article
-
Comparison of Three Interpolation in OFDM Systems
Abstract: Doppler shift and channel induced fading effects are more likely to induce inter carrier interferences (ICI), which are the challenging research area in the orthogonal frequency division multiplexing (OFDM). This paper uses channel estimation for canceling the effects of ICI from the received signals. One dimensional frequency domain comb-type channel estimation are considered because of its low computational complexity and effective tracking ability of the fast fading channel. The channel …
Published in International Journal of Broadband Cellular Communication · Vol. 3, Issue 1, 2017 · pp. 1–9 Read article
-
Modified Multiple Sub-blocking PTS Technique for Reduction in PAPR in OFDM System
Abstract: OFDM (Orthogonal frequency division multiplexing) is a multi-carrier modulation technique which provides better bandwidth efficiency at high data rate but the problem is it increases the PAPR. This increase in PAPR leads to loss of signal and in order rectify it cost of amplifiers has to be increased. Therefore, peak-to-average power reduction (PAPR) reduction is an important issue which is required to be solved. PAPR can be reduced by using …
Published in International Journal of Broadband Cellular Communication · Vol. 4, Issue 2, 2018 · pp. 23–29 Read article
-
Monopole Antenna Designing for Wideband Applications
Abstract: ABSTRACTA microstrip-fed, circular shaped monopole antenna is proposed for wideband applications. As FCC introduced the range of S-band operations from 2 to 4 GHz, antenna was designed to work under this defined range of frequency. Antenna is collected of a partial ground and a Circular-shaped radiating patch that is adapted circle monopole. Antenna can create impedance bandwidths to cover the frequency bands of the S-band (1.9–3.1 GHz). Also, the antenna …
Published in International Journal of Broadband Cellular Communication · Vol. 6, Issue 1, 2020 · pp. 1–4 Read article
-
A Review of Microstrip Patch Antenna for 5G
Abstract: Requirements for mobile communication arise because of the rapid increase in mobile users. Mobile users need to have more features on their mobile phones, such as high date rates, efficient communication, reduced traffic, convenience of using different applications etc. Mobile providers need to address mobile consumer demands that can be achieved with the aid of 5G technology. 5G technology provides very high bandwidth, reduced latency, improved service quality, optimum capacity; …
Published in International Journal of Broadband Cellular Communication · Vol. 6, Issue 2, 2020 · pp. 7–16 Read article
-
Compact Slot Loaded Dual B and Antenna for mm-wave 5G Communications
Abstract: In the presented compact slot-loaded dual-band resonating antenna different slots have been implemented on the patch and ground to achieve good antenna performance characteristics. The antenna was created using a ground plan of 6.57*7.56 mm2 . The proposed antenna is Dual-band resonating at frequencies 26 GHz and 36 GHz along with the gain of 7.92 dBi and 7.04 dBi respectively. U-shape and circular shape slots along with DGS structure are …
Published in International Journal of Broadband Cellular Communication · Vol. 8, Issue 1, 2022 · pp. 20–31 Read article
-
A Brief Review on Induction heating
Abstract: Induction heating is the method of heating an electrically conducting material (usually a metal) by electromagnetic induction, through eddy currents generating heat in the object. An induction heater is an electromagnet and an electronic oscillator that passes through the electromagnet through a high-frequency alternating current (AC). The rapidly alternating magnetic field penetrates the artifact, producing the conductor's electrical currents called eddy currents. The eddy currents flow through Joule heating through …
Published in International Journal of Microelectronics and Digital integrated circuits · Vol. 5, Issue 2, 2019 · pp. 1–10 Read article
-
Evaluation with Wave Propagation Launch Vehicles besides Non-Intrusive Transmission Lines Failure Detection.
Abstract: The whole paper presents a principle of non-intrusive real-time network failure tracking utilizing wireless sensor networks. The core components of the detector are known as energy harvesters, waveforms and algorithms, circuits and components, and surface wave launchers. In this we have discussed a compact energy harvesting system that is capable of non-intrusively extracting power from a power cable. In terms of waveforms and algorithms, we suggest the usage of TDR …
Published in International Journal of Microelectronics and Digital integrated circuits · Vol. 6, Issue 2, 2020 · pp. 12–21 Read article
-
Development of a Ray-tracing Program and its Application in Characterizing the Range of HF Radio Propagation in the Equatorial Ionosphere
Abstract: A ray tracing program which is an algorithm that can be used to describe the complex nature of the ionosphere has been developed using locally available resources. The International Reference Ionosphere (IRI) Ionospheric Model were incorporated into the program for evaluating electron density values. Complex refractive indices of the ionosphere were generated using Appletone-Hartree formula with no collision and magnetic field effects. The program applies Snell’s law of refraction in …
Published in International Journal of Microelectronics and Digital integrated circuits · Vol. 6, Issue 2, 2020 · pp. 1–11 Read article
-
Application of Rectangular Patch Antenna for a Moisture Content Sensor
Abstract: Micro-strip patch antenna is a low cost, easy to fabricate, light weight which is used for transmit and receive electromagnetic wave. This paper tells about the micro-strip rectangular patch antenna moisture sensor for different types of rice which are basmati rice and ambemohar rice both are easily available in Indian market and it has been measured by using two different substrate RT-duroid 5880 and FR4 lossy. A relationship is to …
Published in International Journal of Microwave Engineering and Technology · Vol. 1, Issue 1, 2015 · pp. 5–9 Read article
-
Analysis of a Microstrip Triangular Patch Antenna using DGS as a Strain Sensor
Abstract: Microstrip patch antenna is a plane shape, light weight and low cost antenna that used to receive and transmit electromagnetic wave. This paper describes the design and simulation of a triangular microstrip patch antenna using DGS for strain measurement. The microstrip antenna was designed and simulated using Computer Simulation Technology (CST) Microwave Studio. When the antenna is under strain/crack, its resonance frequency varies accordingly. By using DGS in microstrip antenna …
Published in International Journal of Microwave Engineering and Technology · Vol. 1, Issue 1, 2015 · pp. 10–13 Read article