Search
85 articles for “polarity”
-
THE STUDY OF DIELECTRIC PERMITTIVITY OF NINPs-PDMS
Abstract: Nickel–polydimethylsiloxane (Ni–PDMS) nanocomposites were fabricated to investigate the influence of metallic nanoparticle loading on the dielectric behavior of flexible polymer matrices. Nickel nanoparticles with controlled size distributions were dispersed in PDMS using solution blending and curing protocols optimized to minimize agglomeration. The dielectric permittivity and loss tangent of the resulting nanocomposites were measured across a broad frequency range (typically 10²–10⁶ Hz) and at varying filler volume fractions. Results show a …
Published in International Journal of Electrical Power System and Technology · Vol. 11, Issue 2, 2025 · pp. 39–50 Read article
-
The Future of Radar Antenna Design: A Study
Abstract: Radar antennas are the critical interface between the electronic heart of a radar system and theelectromagnetic waves that probe the environment, acting as the system's "eyes and ears." Theirdesign is a multi-faceted engineering challenge, inherently balancing often-conflictingrequirements to optimize performance across incredibly diverse applications – from long-rangesurveillance and air traffic control to autonomous vehicle sensing and precise weatherforecasting. This abstract introduces the fundamental principles and intricate considerationsgoverning radar antenna design, …
Published in International Journal of Digital Communication and Analog Signals · Vol. 11, Issue 2, 2025 · pp. 43–51 Read article
-
Reactive Separation for Biodiesel Purification Using Hybrid Membrane Systems
Abstract: Biodiesel produced through transesterification typically contains several impurities, including residual glycerol, unreacted methanol, soaps, water and homogeneous catalysts, all of which reduce fuel quality and hinder compliance with EN 14214 and ASTM D6751 standards. Conventional purification techniques such as water washing, centrifugation and vacuum distillation are energy-intensive, generate large volumes of wastewater and often fail to efficiently remove polar contaminants. To overcome these limitations, this study examines a reactive separation …
Published in International Journal of Chemical Separation Technology · Vol. 11, Issue 2, 2025 · pp. 17–30 Read article
-
Microstrip Line Fed Capacitively Coupled Patch Antenna for Wireless Application
Abstract: In order to increase the impedance bandwidth for wireless local area network (WLAN) applications, aunique design of a microstrip line-fed, capacitively coupled, corner-truncated microstrip patch antenna isput forth, examined, and optimized in this research. The low profile, light weight, ease of manufacture,and compatibility with printed circuit technologies of microstrip patch antennas are well known.Conventional patch antennas' intrinsically small impedance bandwidth, however, is a significantdisadvantage that reduces their usefulness in broadband …
Published in International Journal of Microwave Engineering and Technology · Vol. 11, Issue 2, 2025 · pp. 1–9 Read article
-
Thermoacoustic Properties of Ethanol-n-Hexane and 1-Propanol-n-Hexane Binary Mixtures: A Comparative Study at 298.15 K
Abstract: Using an Anton Paar DSA 5000 M instrument, measurements of density, sound velocity, and viscosity were carried out for ethanol–n-hexane and 1-propanol–n-hexane binary mixtures across mole fractions ranging from 0.1 to 0.9 at a constant temperature of 298.15 K. These binary mixtures were specifically selected to investigate the behavior of polar–nonpolar molecular interactions and how they affect the thermophysical properties of the system. The density, sound velocity, and viscosity data …
Published in International journal of Thermodynamics and Chemical Kinetics · Vol. 11, Issue 2, 2025 · pp. 1–8 Read article
-
Review Article: Butyl and Halo-Butyl Rubbers
Abstract: Butyl and halo butyl rubbers are key raw materials for various industries due to their exceptional properties, like permeability to gases, high chemical resistance, and durability. Butyl rubber (IIR) is composed of isobutylene with small amounts of isoprene, offering a low permeability to gases, making it ideal for applications in the automotive, medical, and consumer goods. Butyl Rubber is non-polar nature and possess excellent insulation properties which further enhance its …
Published in International Journal of Polymer Science and Engineering · Vol. 11, Issue 2, 2025 Read article
-
Tailoring Electrolytic Deposition of Zn-Ni Alloys for Superior Corrosion Resistance in Harsh Environments
Abstract: Since Zn–Ni alloy coatings are more resistant to corrosion than pure zinc coatings, they are being researched extensively. In this study, Zn–Ni alloy coatings electrolytically deposited from an acidic sulfate bath are investigated. The study looks into how the microstructure, phase composition, and corrosion resistance of the coatings are affected by deposition factors like pH, current density, and electrolyte composition. X-ray diffraction (XRD), potentiodynamic polarization, and scanning electron microscopy (SEM) …
Published in International Journal of Chemical Engineering and Processing · Vol. 11, Issue 1, 2025 Read article
-
Studies on Functionalized Nonwoven Polypropylene Fabric for Antibacterial & Antiviral Properties
Abstract: Nonwoven polypropylene (NWPP) fabric is a versatile material used predominantly in medical field for hygiene products and for PPE applications. The application of NWPP is limited in disinfectant area due to lack of antimicrobial properties and its non-polar nature. The coating of antimicrobial agents on NWPP fibre is expected to lower down the intensity of communicable microbial infections. The present study involves the surface functionalization of NWPP fibre via plasma …
Published in International Journal of Polymer Science and Engineering · Vol. 11, Issue 1, 2025 · pp. 24–34 Read article
-
Isolation and Characterization of Alkaloidsfrom Ancistrocladus Heyneanus Leaves: A Phytochemical Study
Abstract: Leaves of Ancistrocladus heyneanus were collected from the forest of the Matheran hills of Maharashtra. From these leaves, alkaloids were extracted using dichloromethane, and two new monomeric Naphthyl-iso-quinoline alkaloids, Youndamine A and Ancistrocline were isolated using TLC and HPLC. HPLC/MS and NMR further identified the patient. The present study involves the collection and chemical investigation of the leaves of Ancistrocladus heyneanus, a plant species found in the forested regions of …
Published in International Journal of Analytical and Applied Chemistry · Vol. 10, Issue 2, 2024 · pp. 7–20 Read article
-
Performance Characterization of Couette FlowMembrane Module Through Computational FluidDynamics
Abstract: Membrane-based separation has been in rigorous applications in health services since the last fewdecennia. Dynamic Shear Enhanced Membrane Filtration Pilots (DSEMFPs) is a promising membranemodule. The first reported DSEMFPs was a Couette flow type module in 1985. It was used for collectingplasma from donors. This module consists of two concentric cylinders. The outer one is fixed while theinner one is rotating, having a membrane on the outer surface of it. …
Published in International Journal of Composite Materials and Matrices · Vol. 10, Issue 1, 2024 · pp. 1–5 Read article
-
Hydrodynamic Study Through Computational FluidDynamics of Radial Flow Membrane Module
Abstract: Historically Crossflow Membrane modules came first in the membrane-based separation (MBS)process. Its high shear generation overcomes two non-idealities concentration polarization andsubsequent fouling. Primarily, high shear generation and large surface area create a positive domainfor large applications. Thereafter, feed flow rate-dependent shear generation creates a hindrance.This obstruction is overcome with Dynamic Shear Enhanced Membrane Filtration Pilot (DSEMFPs).Low surface area is a vital drawback of DSEMFPs. This radial flow membrane module with …
Published in International Journal of Polymer Science and Engineering · Vol. 10, Issue 1, 2024 · pp. 8–15 Read article
-
Microneedle platform: An innovative way for transdermal drug delivery system.
Abstract: The transdermal route is employed as an alternate method in many therapeutic applications to get over the important drawbacks of oral medication delivery. Transdermal microneedle arrays have been used for drug administration via the skin for a very long time. Microneedles are devices with a reputation for being highly efficacious and flexible. Microneedles are devices with a reputation for being highly effective and flexible. Intellectual and industrial groups are interested …
Published in International journal of Nanobiotechnology · Vol. 10, Issue 1, 2024 Read article
-
Green Synthesis, Characterization and Antimicrobial Studies of Ni(II) and Cu(II) Schiff Base Complexes
Abstract: Solvent-assisted mechanochemical reaction was used to synthesize new transition metal complexes of Ni(II) and Cu(II) with Schiff base ligand (H2L) obtained from condensation of 2-hydroxy-1- napthaldehyde with 2 aminobenzimidazole. Melting point/decomposition temperature, solubility test, FT-IR, powder x-ray analysis, conductivity measurement, magnetic susceptibility, elemental microanalysis, and UV/VIS spectral investigations were used to characterize the Schiff base and complexes. The complexes are of varied colours and have sharp melting points, and they …
Published in International Journal of Green Chemistry · Vol. 8, Issue 1, 2022 · pp. 9–18 Read article
-
CORROSION RESISTANCE OF BINARY AND TERNARY ALLOY COATINGS FROM ACID SULPHATE BATH
Abstract: Electroplating of three binary (Zn-Ni, Zn-Co and Zn-Fe) and two ternary (Zn-Ni-Co and Zn-Co-Fe) alloy coatings were developed onto mild steel substrate using 2-((4-chlorophenyl) amino)-1-(6-methyl-1H-pyrazolo [3, 4 - b] quinolin-1-yl) ethanone (CME) as an additive. Hull cell technique was used to optimize the bath constituents and operating conditions. Corrosion rate of binary and ternary alloy coatings were determined using potentiodynamic polarization method. Corrosion rate of ternary Zn-Ni-Co alloy coating was …
Published in International Journal of Analytical and Applied Chemistry · Vol. 6, Issue 2, 2020 · pp. 12–16 Read article
-
Macro-compounds and Macro-cycles with Their Applications
Abstract: Macro-compounds represent an ancient class of compounds that enter into coordination chemistry as a ligands such as (crown ethers, aza, thia and others), or in the field of organic chemistry through large cyclic compounds such as porphyrins, vitamins and others, where corona ethers are strongly linked with specific cations forming coordination complexes, In which the oxygen atoms occupy positions suitable for coordination with a cation located inside the ring, and …
Published in International Journal of Analytical and Applied Chemistry · Vol. 7, Issue 2, 2021 · pp. 1–12 Read article
-
Investigating study on flux enhancement techniques in a Nanofiltration pilot plant – An Experimental overview
Abstract: Water consumption and utilization in chemical allied industries is increasing progressively and global availability of fresh water is reducing. Reclamation of water from various industrial waste streams is play very vital role to overcome the current situation of water scarcity. Various conventional treatment methods are available for water reclamation. The performance of the membrane separation process, in terms of flux and rejection of membrane is directly influenced by the resistances …
Published in International Journal of Chemical Separation Technology · Vol. 4, Issue 2, 2018 · pp. 27–34 Read article
-
Influence of CeO2 nanoparticles on the corrosion behavior of electrodeposited Ni coatings
Abstract: Nickel-Ceria (Ni-CeO2) nanocomposite coatings were developed on mild steel (MS) substrate using electrodeposition method. The codeposition of the nanoparticles was achieved from the optimized Ni plating bath loaded with CeO2 nanoparticles (particle size <20 nm). Ni and Ni-CeO2 coatings were achieved at a wide current density (c.d.) range from 1.0 to 5.0 A/dm2 under optimal conditions, and their corrosion protection efficacy was examined in 5% NaCl medium. The material property …
Published in International Journal of Chemical Engineering and Processing · Vol. 2, Issue 1, 2016 · pp. 19–28 Read article
-
Induced codeposition of Ni-W alloy coatings using glycerol as additive and their characterization
Abstract: As a promising coating material to replace hard chromium coating, the development of nickel–tungsten (Ni-W) alloy coatings of good corrosion protection is of great interest in surface coating technology. Further, the effect of plating variables, including additive on the composition of alloys of induced co-deposition is more vagarious than in other types of alloy deposition. In this regard, an alkaline citrate bath has been formulated for electrodeposition of Ni-W alloy …
Published in International Journal of Chemical Engineering and Processing · Vol. 2, Issue 2, 2016 · pp. 1–9 Read article
-
Electrolytic Deposition of Zn–Ni Alloy from Acidic Sulphate Bath and Their Characterization
Abstract: A bath containing ZnSO4.7H2O, NiSO4.7H2O, thiamine hydrochloride (THC) and citric acid (CA) has been proposed. Bright Zn–Ni alloy coatings were developed galvanostatically onto mild steel (MS) and their corrosion resistance and other physical properties were studied. THC was found to improve the brightness and homogeneity of the deposit. The dependency of bath composition, current density (c.d.), pH and temperature, agitation on wt.% Ni were tested. Deposition was carried out under …
Published in International Journal of Chemical Engineering and Processing · Vol. 2, Issue 2, 2016 · pp. 19–32 Read article
-
Physico-Mechanical Performance of Waste Plant Fiber Reinforced Thermoplastic Composites for Automotive Applications
Abstract: To maximize the interfacial bond strength, it is necessary to investigate the direct relationship between the degree of fiber-matrix adhesion and the mechanical and fracture behavior of composites. In this work, the strength of the interfacial bond between polypropylene (PP) and waste plant fiber (Dharose plant fiber, DF) that have been subjected to ultraviolet radiation (UV) was established. By using hot press molding, unidirectional composites of PP with dharose plant …
Published in International Journal of Chemical Engineering and Processing · Vol. 9, Issue 1, 2023 · pp. 14–24 Read article